Crane Limits and Appearance ( Fabricator Settings ) (read-only)
This window shows choices made for this Fabricator in the Site Planning or SDS2 Detailing program.
Method 1 : Home > Project Settings > Fabricator > Crane Limits and Appearance .
Method 2 : In Modeling (classic) or the Drawing Editor (classic), choose Settings > Fabricator Settings > Crane Setup .
Note: You can review the choice made here regardless of whether or not a crane exists in the 3D model.
page 1 | contents | home > project settings > fabricator > | classic | top
Lift capacity limit: read-only . The percentage that is the default " Capacity limit " for a crane that is newly added using Add Crawler Crane or Add Tower Crane in the Site Planning or SDS2 Detailing program.
Working area diagram radius: The radius of the working area shown on a crane placement's working area diagram. A working area is a configuration of a truck or crawler crane's lower works that determines its quadrants of operation. A working area diagram shows these quadrants extended to the radius that you choose.
|
||
| A working area diagram radius is measured from the center of a crane placement. |
Note 1: Some working areas consist of a single 360 degree quadrant. Such diagrams are visible only when " Show diagram for 360 degree rotation working areas " is checked (
).
Note 2: When the project's primary dimension " Units " are imperial (that is, set to ' Imperial (ft-in)' or ' Imperial (inches-sixteenths)' or etc.), this radius is expressed in feet. When the primary dimension " Units " are set to ' Metric ', this radius is expressed in meters. In either case, the radius is always expressed as a whole or decimal number.
Note 3: Working areas are not configured for tower cranes; consequently, working area diagrams are never shown for their placements.
Show diagram for 360 degree rotation working areas: or 
. This applies to truck or crawler crane placements with a single 360 degree quadrant.
|
||
| "Show diagram" has no effect on placements of cranes that have two or more quadrants in their working areas. |
If this box is checked (
If the box is not checked (
Liftable shell opacity: Any level from 0 (transparent) to 100 (opaque). The liftable shell is the dome that is displayed when you left-click a crane in your Modeling view.
|
|
the slider sets the level |
|
||
| The "dome" around the crane placement represents the reach of the crane's boom. The center cylinder is the no-lift zone around the crane. The alternating dark and light bands are each 10 ft in width. |
Working area opacity: Any level from 0 (transparent) to 100 (opaque). This applies to working area diagrams shown for truck and crawler crane placements.
|
|
|
the slider sets the level |
|
||
| When a working area is opaque, member main and member connection material cannot be seen through it. |
page 1 | contents | home > project settings > fabricator > | classic | top