" Gusset 2 Point Square " connection design locks

W tee or channel vertical braces field bolt directly to a shared gusset plate that shop attaches to a column. The corners of the gusset plate *(" Gusset 2 Point Square ") are square due to " Clip end operation " being set to ' No ' or, possibly, to ' Automatic '. This applies to 2-point bracing (shown) and 3-point bracing (not shown).

(WT or C vertical braces, field bolted to shared gusset, to a column) (vertical brace " Section size " = channel or W tee) (for a W tee, " Stem orientation " = ' Horizontal ') (" Input connection type " = ' Vbrc plate ' or ' User defined ') (" Clip end operation " = ' No ' or possibly ' Automatic ')

" Gusset 2 Point Square " (gusset plate dimensions and location)

2-point and 3-point bracing . The connection design locks for 2-point bracing (2 braces to a shared gusset) and 3-point bracing are essentially the same. However, SDS2 connection design will not connect a 3-point gusset plate to the supporting beam with a clip angle. A 3-point gusset plate must be welded to the supporting beam. Related locks : Brace Connection To Gusset (angle) Gusset 2 Point Square (angle) Gusset 2 Point (angle, tee, channel) Weld Conn 2 NS/FS Clip Conn2

user defined | vertical brace review | top

---

Connection design locks :

Locks not on the drawing are marked ( not depicted ).

  Gusset 2 Point Square
( W tee or channel vertical braces, 2- or 3-point, to a column )

Shared gusset plate dimensions and location

Plate thickness ( not depicted ):

Width ( plate width ):

Length ( plate length ):

Refy:

Left Brace [ member number ] (the left brace is the bottom brace if the column is vertical)

Refx ( refx left ):

Right Brace [member number] (the right brace is the upper brace if the column is vertical)

Refx ( refx right ):

user defined | vertical brace review | top