" Gusset 2 Point " & " Weld Conn2 " connection design locks

NS and FS web plates shop bolt to a stem-vertical W tee vertical brace and field bolt to a shared gusset plate for 2-point bracing (" Gusset 2 Point ") or 3-point bracing (not shown). The brace's work line runs through the bolt column nearest the W tee flange. The shared gusset shop attaches to the beam per " Weld Conn2 " locks or, if applicable, " NS/FS Clip Conn2 " locks.


(stem-vertical WT vertical braces, web plates field bolted to shared gusset, to a beam)
(vertical brace " Section size " = W tee)
(" Input connection type " = ' Vbrc plate ' or ' User defined ')
(" Stem orientation " = ' Vertical ')  
(" Connection type " = ' Web plates ')
(" Stem direction " = ' Down ' or ' Up ')
" Gusset 2 Point "
(gusset plate dimensions and location)

" Weld Conn2 "
(" Gusset to supporting member " = ' Welded ')


The connection design locks for 2-point bracing (2 braces to a shared gusset) and 3-point bracing are essentially the same . However, SDS2 connection design will not connect a 3-point gusset plate to the supporting beam with a clip angle (" NS/FS Clip Conn2 " locks) . A 3-point gusset plate must be welded to the supporting beam (" Weld Conn2 " locks).
Related locks :   Brace Connection To Gusset Wtee
Brace Connection To Gusset
NS/FS Clip Conn2

user defined | vertical brace review | top

Connection design locks :

Locks not on the drawing are marked ( not depicted ).

  Gusset 2 Point
( stem-vertical W tee vertical braces, web plates, to a beam )

Gusset 2 Point

Plate thickness ( not depicted ):

Width ( plate width ):

Length ( plate length ):

Refy:

Left Brace [ member number ]

Refx:

Connection cut width ( cut width ):

Connection cut length ( cut length ):

Right Brace [ member number ]

Refx:

Connection cut width ( cut width ):

Connection cut length ( cut length ):

user defined | vertical brace review | top

  Weld Conn2
( stem-vertical W tee vertical braces, 2- or 3-point, to a beam )

Shop weld, gusset to the supporting beam

Weld size ( weld ):

" Weld Conn2 " locks are available when ' Welded ' is selected for " Gusset to supporting member " under " Connection specifications " on the Vertical Brace Review window.

" NS/FS Clip Conn2 " locks are available when ' Clip angle ' is selected for " Gusset to supporting member ."

user defined | vertical brace review | top