The Embed Schedule window ( Job Settings )

• Click here for information on this window from the SDS2 Detailing manual.
• Settings on this window are read-only . They tell you how this window has been set up in a full-featured SDS2 program .
• The link shown above takes you to a different manual, where the Embed Schedule is not read-only.

VIDEO Note: Embed plates, angles and channels are stand-alone custom members . Even though the embed plate shown in this video is from the Embed Schedule and part of an auto standard connection of a beam, its member detail is fully independent of the beam. (Recorded in SDS2 Detailing , v2018.)

	Opens a window that in a full-featured SDS2 program would be used to add a new embed plate . In this program, the window is read-only.
	Opens a window for adding a new angle or channel embed . In this program, the window is read-only.
	Opens a window with settings for the one or more lines that you selected. Double-clicking a line also opens the window. The window is read-only.

page 1 | contents | home > project settings > job > connections > | classic | top