The Member and Drawing Restrictions setup window ( Job Settings )

Settings on this window are read-only . They tell you how this window has been set up for this Job in a full-featured SDS2 program .

page 1 | contents | home > project settings > job > modeling > | classic

---

------ Modeling ------

Restrictive model complete: or . This affects members to which a " Model complete date " is applied only when " Auto " is checked.

If this box is checked ( ) and a " Model complete date " has been set and " Auto " is checked for a specific member, the member is "frozen" in a restrictive manner which protects that member from being altered in almost any way . Click here for more information.

If the box is not checked ( ) and a " Model complete date " has been set and " Auto " is checked for a specific member, the member's solids model is protected from changes. Click here for more information.

Regardless of the choice made here: If member " Operations " is turned on ( ) in Event Logging Setup , the setting of a " Model complete date " is reported as " Model compete date set " in the " Log " of the affected member. The " Log " reports " Model complete date cleared " when the " Model complete date " is changed to ' **NOT SET** '.

Member windows: Model complete date
Status Report by XXX: Model complete

Prompt to lock ends on legacy model complete members: Not applicable to this program.

You cannot change a member's " Model complete date " in an SDS2 review station , and therefore you will never be prompted to lock member ends.

Prompt to lock ends on restrictive model complete members: Not applicable to this program.

You cannot change a member's " Model complete date " in an SDS2 review station , and therefore you will never be prompted to lock member ends.

Allow model complete date override: Not applicable to this program.

------ Drawing Editor ------

Allow detail freeze date override: Not applicable to this program.

page 1 | contents | home > project settings > job > modeling > | classic | top