" Gusset 2 Point " & " Weld Conn2 " connection design locks
Angle, W tee or channel vertical braces field bolt directly to a shared gusset plate (" Gusset 2 Point ") that shop attaches to a column. The gusset plate's corners are clipped pependicular to each brace's workline due to " Clip end operation " being set to ' Yes ' or, possibly, to ' Automatic '. This help page applies to 2-point bracing (shown) and 3-point bracing (not shown). Gusset-to-column shop attachment is per choices made to " Weld Conn2 " or, for 2-point, " NS/FS Clip Conn2 ." |
|
|||||
" Gusset 2 Point "
(gusset plate dimensions and location) |
" Weld Conn2 "
(" Gusset to supporting member " = ' Welded ') |
||||
|
user defined | vertical brace review | top
Connection design locks :
Locks not on the drawing are marked ( not depicted ). |
Gusset 2 Point
( angle, W tee or channel vertical braces, 2- or 3-point, to a column )
Shared gusset plate dimensions and location
Plate thickness ( not depicted ):
Left Brace [ member number ] (the lower brace is the left brace if the column is perfectly vertical)
Right Brace [ member number ] (the upper brace is the right brace if the column is perfectly vertical)
Refx ( refx right ):
Connection cut width:
Connection cut length:
user defined | vertical brace review | top
Weld Conn2
( angle, W tee or channel vertical braces, 2- or 3-point, to a column )
Shop weld, gusset plate to the supporting column
Weld size ( weld ):
" Weld Conn2 " locks are available when ' Welded ' is selected for " Gusset to supporting member " under " Connection specifications " on the Vertical Brace Review window.
" NS/FS Clip Conn2 " locks are available when ' Clip angle ' is selected for " Gusset to supporting member ."