The Event Logging setup window ( Job Settings ) ( enabled )

  • Exit the program to activate changes! Modeling sessions of that same Job that are run concurrently to your making a change to a setting on this window are not affected.
  • Choices made here begin to apply when you first start your next Modeling session and continue to apply until you Exit Modeling .
  • This window affects your current Job only.

Warning: These links (to your left) take you to the SDS2 Detailing help manual on event logging. You will no longer be in the help manual forSDS2 Site Planning when you click one of these links.

Logged events in Site Planning are few since so much of the program's interface is read-only.

If you share this Job with users of a full-featured SDS2 program on the same network, you can turn on/off the recording of events that are logged by those users.

If Site Planning is on a network that is independent of the full-featured SDS2 program that sent you your current Job , you can still review the event log of that Job, and this window can tell you how that log was set up.

The links on this page take you to the SDS2 Detailing documentation because that documentation gives you the complete story on event logging.

If you change settings on this window, you will affect the logging of future events, but an already recorded log of past events will not be affected. Exit the program to activate changes .

Also see :

Tip: For tracking changes made to a Job in SDS2 Site Planning, you may want to record " Status " events. Most other events are not recordable in an Site Planning.

page 1 | contents | home > project settings > job > modeling > | classic | top

  To open Event Logging Setup :

Method 1 : Home > Project Settings > Job > Modeling > Event Logging .

Method 2 : In Modeling or the Drawing Editor , choose Settings > Job Settings > Modeling > Event Logging (classic), or use a keyboard shortcut or click the icon.

page 1 | contents | home > project settings > job > modeling > | classic | top