The Beam Bearing Plate setup window (Job Settings)

Documentation in progress

The links at left take you to the Beam Bearing Plate custom component window.

When you add a beam bearing plate for the first time in a Modeling session, the Beam Bearing Plate window is populated with settings from this window. Thereafter, during that same Modeling session, each subsequently added beam bearing plate custom component will use the settings from the bearing plate that was last added or last edited.

home > project settings > job > plugin defaults > component plugin defaults >

To close Beam Bearing Plate Setup:

  

"OK" (or the Enter key) closes the Beam Bearing Plate setup window and saves the settings on it to the Job Settings file loaded with your current Job. These options are applied the next time you start a new Modeling session and add a beam bearing plate component.

"Cancel" (or the Esc key) closes this window without saving any changes made to it.

home > project settings > job > plugin defaults > component plugin defaults > | top