The Beam Flange to Flange Connection window ( Job Settings )
When you add a flange-to-flange connection to two beams for the first time in a Modeling session, the Beam Flange to Flange Connection window is populated with settings from this window. Thereafter, during that same Modeling session, each subsequently added beam flange to flange custom component will use the settings from the flange to flange connection that was last added or last edited.
home > project settings > job > plugin defaults > component plugin defaults >
To close Beam Flange To Flange Connection :
"OK" (or the Enter key) closes the Beam Flange To Flange Connection setup window and saves the settings on it to the Job Settings file loaded with your current Job . These options are applied the next time you start a new Modeling session and add a new flange to flange connection.
"Cancel" (or the Esc key) closes this window without saving any changes made to it.
home > project settings > job > plugin defaults > component plugin defaults > | top