C beam, left end, toe in

Click a point label ( A or B or etc.) to get an expression defining that point

point	position on left end plane	mem.left.location + mem.trans_to_global ( X , Y , Z )
		X	Y	Z
A	top corner of heel	mem.left.minus_dim	0	0
B	heel, half depth	mem.left.minus_dim	- mem.depth*.5	0
C	bottom corner of heel	mem.left.minus_dim	- mem.depth	0
D	top flange gage line	mem.left.minus_dim	0	mem.gage
E	top flange, corner of toe	mem.left.minus_dim	0	mem.bf
F	web, toe of upper fillet	mem.left.minus_dim	- mem.k	mem.tw
G	web, half depth	mem.left.minus_dim	- mem.depth *.5	mem.tw
H	web, toe of lower fillet	mem.left.minus_dim	- mem.depth +mem.k	mem.tw
I	bottom flange, corner of toe	mem.left.minus_dim	- mem.depth	mem.bf
J	half depth, aligned with channel toes	mem.left.minus_dim	- mem.depth *.5	mem.bf

---

Columns on the above table :

point - the points ( A , B , etc.) in the above parametric point map are a few examples of reference points.

position on left end plane - entries to this column on the table describe (in words) the position where a particular point (A or B or etc.) is placed on the left end plane of a "toe in" channel beam.

mem.left.location + mem.trans_to_global(X,Y,Z) - an expression similar to this one is automatically entered to the " Point 1 " and " Point 2 " fields of the parametric material window that appears when you Add Material operation. The expression "mem.left.location" is the left end work point of the member. The operation "+ mem.trans_to_global(X,Y,Z)" defines individual X, Y and Z member coordinate distances and adds those distances to the member's left end work point in order to define a new point in global coordinates .

X is the X member coordinate distance from the left end member work point (mem.left.location) where the new point generated by the parametric will be placed. As illustrated above , a positive X distance translates the point away from the left end work point of the beam (the beam's 0,0,0 point ) and toward the right end, whereas a negative X distance translates the point in the opposite direction.

Y is the Y member coordinate distance from the left end member work point (mem.left.location) where the new point generated by the parametric will be placed. As illustrated above , a positive Y distance places the point above the top flange of the beam, whereas a negative Y distance places the point below the top flange.

Z is the Z member coordinate distance from the left end member work point (mem.left.location) where the new point generated by the parametric will be placed. As illustrated above , for a "toe in" channel beam a positive Z distance translates the point away from the heel of the channel and in the direction that the channel toes point, whereas a negative Z distance places the point on the far side of the beam workline (off of the material).