The Seismic Stirrup Hook setup window ( Job Settings )
 |
Two ways to open this window:1) Double-click a seismic stirrup hook " Shape Operation " at Home > Project Settings > Rebar > the Standard Rebar Bends window. 2) Press " Add " on that same window then select ' Seismic Stirrup Hook '. |
------ Hook Length ------
Parameter type: Auto or Fixed Value or Variable .
' Auto ' lets the program determine the hook length.
' Fixed Value ' sets the hook length to the " Value " entered below.
' Variable ' sets the default hook length to the " Value " entered below and permits that hook length to be adjusted. The label for referencing the hook length is the " Label " specified below.
Label: A or B or C or etc . This applies when the hook length " Parameter type " is ' Variable '.
Value: The hook length when the hook length " Parameter type " is set to ' Fixed value ' or ' Variable '. This is the distance in the primary dimension " Units " (or other units ) from the unattached end of the hook to the fixed end of the hook. This is the unbent length of the hook.
------ Hook Diameter ------
Parameter type: AUTO or Fixed value or Variable .
' Auto ' lets the program determine the hook diameter.
' Fixed Value ' sets the hook diameter to the " Value " entered below.
' Variable ' sets the default hook diameter to the " Value " entered below and permits that diameter to be adjusted. The label for referencing the diameter is the " Label " specified below.
Label: a or b or c or etc . This applies when the hook diameter " Parameter type " is ' Variable '.
Value: The hook diameter (a distance in the primary dimension " Units " or other units ). This applies when the hook diameter " Parameter type " is set to ' Fixed value ' or ' Variable '.
------------
Angle: 135 or 90 or -90 or -135 . The positive or negative number of degrees of separation between the hook's loose end and its fixed end.
Placement point: ' 
No placement point ' or ' At start tangent of inside bend ' or ' At center of inside bend ' or ' At end tangent of inside bend ' or ' At center of hook ' or ' At angle from start of bend ' or ' At intersection of segment center lines ' or ' At intersection of outside tangent lines ' .
The placement point that is set here applies when you choose which continuous bars you want to be constrained by a tie -- for example, when you " Add " a tie to a template in the Column Template Editor .
For the option '
a = " Angle [offset]" of placement point from start of bend
g = " Gap " between placement point and bend.Angle [offset]: The angle from the start of the bend by which the placement point is offset. The applies when you select '
Gap: The distance by which the placement point is offset from the inner edge of the rebar bend. The applies when you select '
concrete | rebar shape template editor | top
To close the Seismic Stirrup Hook window :
"OK" (or the Enter key) closes the Seismic Stirrup Hook window and temporarily records your changes. The Rebar Shape Template Editor is reactivated and, if applicable, changes that you made on this window will be applied to the picture shown on that window. Your changes will be permanently saved when you press " OK " on the Rebar Shape Template Editor ,
"Cancel" (or the Esc key or the
button) closes this window without saving any changes made to it.
"Reset" undoes all changes made to this window since you first opened it. The window remains open.
