The Additional Bars - Beam window ( Job Settings )

Most of the links at left take you to the Additional Bars - Beam window that opens in Modeling when you add the Additional Bars - Beam custom component to a cast in place beam. When you select a column and add an Additional Bars - Beam custom component in Modeling , the Additional Bars - Beam window is populated with settings from this window. Thereafter, during that same Modeling session, new instances of that same custom component will use the settings from the Additional Bars - Beam component that was last added or last edited.

home > project settings > job > plugin defaults > component plugin defaults >

---

To close Additional Bars - Beam :

   

"OK" (or the Enter key) closes the Additional Bars - Beam window and saves the settings on it to the Job Settings file in your current Job . These options are applied the next time you start a new Modeling session and add a column dowel custom component to a column.

"Cancel" (or the Esc key) closes this window without saving any changes made to it.

home > project settings > job > plugin defaults > component plugin defaults > | top