Adjust HandRail Splice ( Modeling )

Tool summary :

  • Lets you move handrail splice points.
  • Adjust HandRail Splice is an icon that you can add to a toolbar (classic) or the ribbon in Modeling (lightning). It can be found the command group named ' Model -- Parametric '. For the lightning interface, use Customize Interface to configure the ribbon.
  • Also in ' Model - Parametric ', you can find the Handrail Tools icon, which gives you another way to launch Adjust HandRail Splice .

Also see :

VIDEO Member ends ( ) need to be selected during a handrail operation such as Adjust HandRail Splice . This video shows how to turn on " Member ends always displayed " in Display Options . You can select member ends even when they are not displayed, but you may find it easier to select them when they are always displayed.. (Recorded in SDS2 Detailing , v2017.)

VIDEO Adjust HandRail Splice is used to remove the splice between two handrail members. As a result, the two members become a single handrail member. (Recorded in SDS2 Detailing , v2017.)

VIDEO Adjust HandRail Splice is used to set back the spliced end of one handrail member from that of another handrail member and thus create a gap between the two members. The two members are then edited and given posts (instead of splices) for ends. (Recorded in SDS2 Detailing , v2017.)

page 1 | contents | handrail (index) | handrail tools