The Beam Nailer Holes window ( Job Settings )
Most of the links at left take you to the Beam Nailer Holes window that opens in Modeling when you add the Beam Nailer Holes custom component to a beam.
When you select a beam and add a Beam Nailer Holes custom component in Modeling , the Beam Nailer Holes window is populated with settings from this window. Thereafter, during that same Modeling session, new instances of that same custom component will use the settings from the Beam Nailer Holes component that was last added or last edited.
home > project settings > job > plugin defaults > component plugin defaults >
"OK" (or the Enter key) closes the Beam Nailer Holes setup window and saves the settings on it to the Job Settings file loaded with your current Job . These settings are applied the next time you start a new Modeling session and add a nailer holes custom component to a beam.
"Cancel" (or the Esc key) closes this window without saving any changes made to it.
home > project settings > job > plugin defaults > component plugin defaults > | top