The Outrigger Setup window ( Job Settings )

Most of the links take you to the *Outrigger* window that opens when you add the *Outrigger* custom component to a wide flange or welded plate wide flange beam.
When you select a beam and add an *Outrigger*custom component in *Modeling* , the *Outrigger* window is populated with settings from this window. Thereafter, during that same *Modeling* session, outriggers that are added using that same custom component will use the settings from the *Outrigger* component that was last added or last edited.
To open this window,*Home > Job > Plugin Defaults > Component Plugin Defaults >* double-click " *Outrigger* ."

To close Outrigger Setup :

"OK" (or the Enter key) closes the Outrigger Setup window and saves the settings on it to the Job Settings file loaded with your current Job . These options are applied the next time you start a new Modeling session and add an Outriggers custom component to a beam.

"Cancel" (or the Esc key) closes this window without saving any changes made to it.

home > project settings > job > plugin defaults > component plugin defaults > | top