The  Wall Dowel setup window ( Job Settings )

Most of the links at left take you to the Wall Dowel window that opens in Modeling when you add the Wall Dowel custom component to a concrete column, a cast in place column, or a pilaster. When you select a column and add an Wall Dowel custom component in Modeling , the Wall Dowel window is populated with settings from this window. Thereafter, during that same Modeling session, new instances of that same custom component will use the settings from the Wall Dowel component that was last added or last edited.

home > project settings > job > plugin defaults > component plugin defaults >

---

To close Wall Dowel setup window :

   

"OK" (or the Enter key) closes the Wall Dowel window and saves the settings on it to the Job Settings file loaded with your current Job . These options are applied the next time you start a new Modeling session and add a column dowel custom component to a column.

"Cancel" (or the Esc key) closes this window without saving any changes made to it.

home > project settings > job > plugin defaults > component plugin defaults > | top