HSS Cap Plates Setup ( Job Settings )
When, for the first time in a Modeling session, you add an HSS cap plate to a non-miscellaneous HSS rectangular (tube) or HSS round (pipe) member, the HSS Cap Plates window is populated with settings from this window. Thereafter, for the duration of that same Modeling session, each subsequently added HSS cap plate custom component will use the settings from the cap plate that was last added or last edited.
home > project settings > job > plugin defaults > component plugin defaults >
To close HSS Cap Plates Setup :
"OK" (or the Enter key) closes the HSS Cap Plates Setup window and saves the settings on it to the Job Settings file loaded with your current Job . These options are applied the next time you start a new Modeling session and add a new HSS cap plates component to an HSS round (pipe) or HSS rectangular (tube) member.
"Cancel" (or the Esc key) closes this window without saving any changes made to it.
home > project settings > job > plugin defaults > component plugin defaults > | top