" 
Brace Connection To Gusset " connection design locks
|
A stem-vertical W tee vertical brace field bolts directly to its gusset plate per choices made to " |
|
|||
| " Brace Connection To Gusset "
( hole pattern for field bolts )  |
|
||
User Defined Connections: Settings that are locked (
) in the user defined connection file will automatically be locked on the member edit window. You can, if you so choose, manually lock additional settings on the member edit window, and your changes will be retained, through multiple processes, so long as you do not change to a different connection then switch back to the original user defined connection.
Vertical Brace Edit: To change a setting, first set it to locked (
) may be updated, and the "
VIDEO 
A stem-vertical W tee vertical brace has its " Connection type " set to ' Coped flange ' and its " Side of gusset " set to ' Near side ' then to ' Far side '. (Recorded in SDS2 Detailing , v2016.)
user defined | vertical brace edit | top
Connection design locks :
| Locks not dimensioned or called out on the drawing are marked ( not depicted ). |
Brace Connection To Gusset
( stem-vertical tee vertical brace, coped flange, to a column & base or cap plate )
Bolt diameter ( not depicted ): You can either type in any diameter (inches or mm), or you can select a bolt diameter from the combo box (
). The diameters that are listed in the combo box come from Home > Project Settings > Job > Bolt Settings > the " Available bolt diameters " list. The bolt diameter entered here, together with the " Hole type " entered below, set the diameter of holes through the gusset plate.
Hole type ( not depicted ): Standard round or Short slot or Oversized or Long slot or User slot #1 or User slot #2 . The hole type selected here, together with the " Bolt diameter " entered above, set the diameter of holes for field bolting the stem-vertical W tee brace to the gusset plate.
Rows: The total number of holes in any column of holes in the gusset plate (see example ). Bolt row spacing on a vertical brace gusset plate runs parallel with the work line of the vertical brace. For the stem-vertical tee vertical brace shown in the example above, the number of " Rows " is ' 2 '.
Distance to 1st hole along brace ( to 1st hole ): The distance (parallel with the work line of the vertical brace) from the work point for this end of the vertical brace to the center of the nearest hole in the gusset plate (see example ).
Hole spacing along brace ( rsp ): Row spacing. This is the distance (center to center) between of any two adjacent holes in the same column of holes in the brace-to-gusset connection (see example ).
End connection failure message: Invalid bolt spacing
Edge distance along brace ( ed ): The distance from the forward edge of the vertical brace to the nearest hole. This distance is measured along the work line of the stem-vertical W tee brace. The forward edge brace's edge that is nearest to the work point. In other words, it is the edge that is nearest to the column.
Other edge distance along brace ( oed ): The distance from the connection edge of the gusset plate to the nearest hole for field bolting the brace to the gusset. This distance is measured along the work line of the stem-vertical W tee vertical brace.
Columns: The number of columns of holes in the gusset plate (see example ). These holes will be used for field bolting the vertical brace to the gusset. In the example above, the number of " Columns " is ' 2 '.
Hole spacing perpendicular to brace ( csp ): Column spacing. This is the distance (center to center) between any two columns of holes (see example ). Bolt column spacing runs perpendicular to the work line of the vertical brace. Holes within an individual column run parallel with the work line.