Add Components or Member Ends to a Connection Cube

Adds selected connection components or member ends to a connection cube.

1. Preselect a Connection Cube to enable the Connection Cubes contextual page and click the Add Components or Member Ends to a Connection Cube icon found in the Modify section.

Alternative: Invoke Add Components or Member Ends to a Connection Cube using the Find Tool by searching the command name and clicking the icon, which is pictured above.

2. The status line prompts, "Select elements to add to ConnCube". When you are done selecting connection components and member ends, press Enter or right-click and select OK to add them to the Connection Cube.

Alternative 1: If you did not preselect in step 1, the status line prompts, "Select ConnCube for adding elements". Select a Connection Cube, press Enter or right-click and select OK, then follow step 2.

Alternative 2: Press Esc or right-click and select Cancel to end the command without adding connection components and member ends to the Connection Cube(s).

  • Before invoking Add Components or Member Ends to a Connection Cube, make sure to turn on the display of Connection Cubes in Display Options.