Remove Components or Member Ends from a Connection Cube

Removes selected connection components and member ends from a connection cube.

1. Preselect a Connection Cube to enable the Connection Cubes contextual page and click the Remove Components or Member Ends from a Connection Cube icon found in the Modify section.

Alternative: Invoke Remove Components or Member Ends from a Connection Cube using the Find Tool by searching the command name and clicking the icon, which is pictured above.

2. The status line prompts, "Select elements to remove from ConnCube". When you are done selecting connection components and member ends, press Enter or right-click and select OK to remove them from the Connection Cube.

Alternative 1: If you did not preselect in step 1, the status line prompts, "Select ConnCube for removing elements". Select a Connection Cube, press Enter or right-click and select OK, then follow step 2.

Alternative 2: Press Esc or right-click and select Cancel to end the command without removing connection components and member ends from the Connection Cube(s).

  • Before invoking Remove Components or Member Ends from a Connection Cube, make sure to turn on the display of Connection Cubes in Display Options.