Bolt Properties Command

1 . Preselect a bolt to enable the Bolts contextual page and click the Bolt Properties icon found in the Modify section. Skip step 2.

Alternative : Invoke Bolt Properties using the Find Tool by searching the command name and clicking the Bolt Properties icon, which is pictured above. Proceed to step 2.

 Learn more about  alternative methods for launching commands.

2 . In Select Items mode, use Select or Select + (or draw an area box ) to select the bolt(s) for which you want to view the properties. You may want to set the selection filter to ' Bolts '.. Use Select- if you want to deselect bolts.

3 (if required) . This step is required if you did not select bolts in step 2 .

3a : Select Item(s) mouse bindings are activated, and the status line prompts you to " Select bolt(s) to edit properties ." Press the Enter key or right-click ( Menu ) and choose " OK " on the menu when you are done selecting the bolts you want. Go to step 4.

Alternative : You can press the Esc key (or right-click and choose " Cancel " on the context menu ) if you want to end this operation without editing properties. Do not continue.

4 . The following happens:

Possibility 1: If the " Flavor " that was selected at the time your current Job was created was a modular flavor, the Edit Properties window opens.

Possibility 2: If the " Flavor " was a legacy flavor, the Custom Properties window opens.

4a: Regardless of the name of the window that opens, any changes that you make to properties on that window will be applied to all bolts that you selected in step 1 (or step 3) at the time that you press " OK " to close that window.