Saw Report
| A Saw Report cannot be generated for a material that does not have web cuts or flange cuts -- you will get the error message " No end cuts or copes detected " or, if " Disable error checking " is checked, you will simply not get a report. |
About this report :
Step-by-step instructions :
- Step 1: Before generating the report
- Steps 2, & 3: Open Report Selection , select 'Saw Report' , press "OK"
- Step 4: Select each material you want a report on
- Step 5: A report or error message is output for each material selected
CNC contents | CNC main menu | report selection
Example :
"B_87" is the piecemark of the member whose main material this report describes.
CNC contents | CNC main menu | report selection | top
Material information on the report :
Fabricator: The name of the current Fabricator .
Job: The name of the current Job .
Piecemark: A member piecemark or submaterial mark .
If you generated this report by detail or detail sheet, the piecemark listed here is a member piecemark , and the fabrication information presented in the report is for the main material of that member.
If you generated your report by submaterial or gather sheet, the piecemark listed here a submaterial mark .
Section Size: The shape " Description " that conventionally describes the material.
| Section naming conventions :
|| wide flange || channel || angle || tube || plate || flat bar || |
For materials other than plates or flat bars, this section size must be present in your Job's local shape file for it to be included here.
Quantity: The total number of pieces of the member main material or submaterial whose member piecemark or submaterial mark is printed at the top of the report.
Note: There are cases where the member piecemark will have a different quantity than you would get were you to generate this same information for the submaterial mark. This happens when the main material for one member is exactly the same submaterial used for a different member (for instance, in a different sequence).
Length: The overall length of the material. This information comes from the 3D model .
Web: Web depth x web thickness . This information comes from the local shape file .
| d = depth |
|
| tw = web thickness |
|
Flange: Flange width x flange thickness . This information comes from the local shape file .
| tf = flange thickness |
|
K Distance: The distance from the bottom of the radius of the W , L or C section to the top of the flange. This information comes from the local shape file .
k = k distance
K1 Distance: The distance from the web center line to the edge of the radius of a W , C or L section.
k1 = k1 distance
CNC contents | CNC main menu | report selection | top
Web and flange cut data :
Left Web Cut: The angle (in degrees) of the cut to made on the left end of the material's web. 0 means no cut has been made. This information comes from the 3D model .
-10 degrees
 |
0 degrees
 |
10 degrees
 |
R Web Cut: Same as " L Web Cut ," except that this applies to the right end of the material.
-10 degrees
 |
0 degrees
|
L Flange Cut: The angle (in degrees) of the cut to made on the left end of the material's flange. 0 means no cut has been made. This information comes from the 3D model .
-10 degrees
 |
0 degrees
 |
10 degrees
 |
R Flange Cut: Same as " L Flange Cut ," except that this applies to the right end of the material.
-10 degrees
 |
0 degrees
|