- These are the same tools that are on the Navigate menu in Modeling . For the most part, you will want to avoid using them to create complex isometric views in the Assembly Editor .
- A simple plan view or elevation view is usually ideal for performing a Model > Assembly > Add operation in Modeling , and the same rule of thumb applies in the Assembly Editor . The view that is saved with an assembly in the Assembly Editor is the view that was current when you last defined the reference point of the assembly, for example, by using File > Save .
Navigation Mode
Center
Translate
Zoom In 10%
Zoom Out 10%
Zoom In to Region
Zoom Out to Region
Zoom to Fit
Unzoom
Pan
Pan Up
Pan Down
Pan Right
Pan Left
Rotate
Rotate X
Rotate Y
Zoom In to Pointer
Zoom Out to Pointer
Zoom In to Center
Zoom Out to Center
Seek to Face
Seek to Point
Plumb View
Surface Mode
Snap to Surface
Snap to Farside Surface
Snap to Adjacent Surface
Rotate View
Navigate Once
page 1 | contents | assembly editor | top